Search results

Hi, I realize this is a long overdue response so I apologize for that. I am guessing you already realize that you cannot use a GPI for this type of direction detection unless you maybe used the GPI to actually turn on specific reader or antenna port which is then indirectly indicating direction

Hi, Your project sounds interesting but I am afraid I cannot offer any specific advice. This forum is more specifically for our ClearStream software If I had to completely guess, you may have a hardware issue with one of the modules or your code is not quite correct in handling multiple...

Hi Patrick, Yes, Clearstream has the option to convert hex to ascii. This is in the Reader Settings under the Tag Settings tab. **I apologize for the delayed response. I did not notice this question come in until just now.

Hi, It sounds like you have that configured correctly so your next best bet might be to contact our support group if you cannot figure it out.

Hi Sharon, I apologize for such a long delay in answering. Your question did not float to the top of unanswered so it was missed at the time. This type of question is certainly allowed but these forums are mostly on the technical side so our technical folks may not have the answers you are...

Hi, Yes, this should be possible with the correct hardware and software (making some assumptions on the interface for the stopwatch). Using our ClearStream RFID software, you can turn on/off a GPIO port which could be used to signal external systems; in your case the stopwatch. Some of this...

Hi, This should not be an issue in trial mode. I assume the 2 antennas are connected to 1 common reader which is then talking to the one single process? If so, that should be ok.

Hi, I apologize that I do not fully understand the question but I will attempt to answer. Most of the data cleaning and analog processing of the tag reads occur at the hardware level so it would be a more hardware specific question if that makes sense. Since ClearStream RFID is mostly hardware...

Hi, That does sound correct but could also depends on the configuration you are using to trigger that input. If you have an account rep with us, your best bet may be to contact them to see about sending over your config settings for us to review.

Hi, There is a mappable field called Start Event that is used to store this exact option. When this field is selected/mapped, it will store the GPI Trigger Name that you assigned when creating the trigger in the reader configuration area. I think that would be what you are looking for in your...

Hi Andy, I have added this to our feature wish list for our next upcoming release.